The included instructions are easy to follow and the charger is ready to go right out of the box. Connect the terminals per the instructions for what you are charging; plug the charger into a standard wall outlet (check for fault light indicating an incorrect connection) then press the one and only button to toggle to the desired amp level (explained in the instructions).
The amp levels are easy to see so selecting the correct one is easy to do. This charger is also fully automatic and will properly charge the battery on it's own at it's own pace for best performance and battery safety. The charger will tell you when it's done charging or if anything is wrong (if that's the case it will display the fault light or will just shut down).
I really like the foolproof design and features (the cables store in the back of the charger) of this simple easy to use charger. I'm not a very handy guy and electricity does make me a little nervous, but using this charger has been a great experience and a joy to use. Whether pro or beginner if you need a battery charger but are a little intimidated by the experience try this one you'll love it!
Click Here For Most Helpful Customer Reviews >>
This unit works very well for topping off a battery that is low or maintaining the charge on a battery in storage. However, if the battery is fully discharged, the units automated protection feature will give a fault status and refuse to charge it until you use some other method to force a partial charge on the battery.Best Deals for Black & Decker VEC1086BBD Smart Battery 6/4/2 Amp Battery Charger
I charged a dead car battery using the VEC1086BBD. When used correctly this unit revived a battery that had been dead for a year after a 1.5 hour charge.READ THIS IS YOU'VE HAD PROBLEMS CHARGING A CAR BATTERY W/ VEC1086BBD:
(and the instructions didn't help)
-Once you have attached the leads to the battery with the proper polarity and plugged the charger into an AC source, the charger will make a humming noise, but it is NOT charging yet.
-Activate the unit by depressing the button (there's only one button) and repeat to cycle through the 6/4/2 amp settings. If it goes into fault
Press the button again repeatedly if needed until it gets out of fault mode. Press firmly and deliberately!
Additional button presses will cycle to your desired current setting (6A or 4A).
The GREEN LED must be lit or the device is not charging! This may all sound obvious but it was a REAL PAIN and a GIANT waste of time to figure this out.
Warning: **If you rapidly and repeatedly press this button you may cause the circuit breaker in your house to shut off power in your home. Not a big deal though. Just go reset the house breakers.
One more thing I noticed:
After you set to 6A/4A/2A, observe the unit for about 30 seconds until it has stabilized. Check on it periodically thereafter. This is because the unit drifts sometimes into fault mode--by itself.
Hope this helps.
Honest reviews on Black & Decker VEC1086BBD Smart Battery 6/4/2 Amp Battery Charger
This is the first of two B&D battery chargers that I have had that ceased working within two uses. While it seems decent enough at first, the single push button control doesn't provide much info when you can't get off the "fault" light. I have followed all of the instructions, tested the power sources, and even attempted to charge different batteries. It's just not working anymore and I couldn't have babied it more than I did.If you are looking for a product that will do what it says (and presumably that's why you bought it) every time you use it then this isn't for you. Sure, it's cute and friendly looking, but when you need a battery charged, you want it charged. This unit didn't do it for me. With the money I've invested going into my third charger/starter I could have bought a commercial unit instead that would have delivered on its promise. (sigh)
No comments:
Post a Comment